What's Included and Excluded - EV Extras Installation Service

 

What’s Included & Excluded -  Full Installation Service

Standard Installation

EV Extras "Standard Installation" package includes the following:

  • Fitting of the charger( Charger supplied by you) on a brick or plaster wall or to another suitable permanent structure.The charger must be fixed to a main property and be able to utilise the property’s earthing arrangement.
  • Up to 15 metres of surface mounted cable, run and neatly clipped to the wall between the electricity distribution board/consumer unit and the charger point. This cable must be located at a height of no greater than 1.8m from ground level. Should an additional cable length be required a further charge will apply of £18 per metre inc VAT.
  • Routing of the cable through a drilled hole in the wall up to 500mm (20 inches) thick, if required.
  • Fitting and testing of electrical connections and protections required for the charger including all earthing requirements.
  • A protection device (RCD or an MCB) on the properties electricity distribution board/consumer unit for connection of the charger circuit to the mains supply (assumes a spare slot/way on the existing electricity distribution board/consumer unit).
  • Small materials and fixings.
  • We endeavour to be as helpful as possible and provide instruction on the charger installed but it should be noted that the customer may have to refer to the charger manufacturer for specific software instructions.  

 Not included:

  • The EV charger
  • Any type of civil work (digging, grooves, etc.)
  • Masonry, paint, groundworks or plumbing works.
  • Internal trunking. 
  • Installers are not able to work in crawl spaces, on roofs or in lofts if it is deemed unsafe by them.
  • Installers are not able to work in extreme weather (i.e. flooding or intense rain).
  • Any other item or work not specified and not included above.

Standard Consumer Plus Installation

“Standard Installation” as shown above.

PLUS

  • all wiring and connections via a Henley block from the existing electric board to a new mini consumer unit. 
  • a mini consumer unit suitable to provide two spare "ways".
  • the fitting of the Henley block and mini consumer unit on a brick or plaster wall or to another suitable permanent structure of the Henley block and the main consumer unit. 

Not included:

  • The EV charger.
  • Masonry, paint, groundworks or plumbing works.
  • Internal trunking. 
  • Installers are not able to work in crawl spaces, on roofs or in lofts if it is deemed unsafe by them.
  • Any other item or work not specified and not included above.